Heosafe Gera Flushmount Outer Lock

Assembly instructions

•at the closed door place the lock case at the level you want

•take care of the space between the doorframe (at least 3 mm) and the gumseal of the door. Close and open the door with the lock case in its position. If necessary, increase the distance at the doorframe or place again the lock case.

•mark the place with a pencil

•place the drilling stencils (draft 1) and mark precisely the holes

•drill first with a ø 3mm borer, verify than drill with a ø11mm borer

•Cut out a rectangle between the 11 mm diameter bore holes (Illustration 1)

•push out the bolt ( it passers over the doorframe) and fix the lock case in the marked place

•if necessary, the detachment plates may be placed between the door and the lock case so the distance between the bolt and the doorframe (with the door closed) be aprox. 1mm (draft 2)

•place the outer lock with the keys out

•remove the back plate of the lock case by removing both the screws M4 draft 3) and place it so that loosing spike A (draft 4) is down.

•fix the back plate on the outer case with screws and cut evenly the loosing bar B (draft 4).

•fix the lock case on the back plate and ensure with screws M4 (draft 5)

•screw streght all the screws

•you donʼt need electronic drill.